INSTALLATION PROCEDURE: 92101 BRACKETS
1) Orient the bracket and switch with PHD logo / LED facing up as shown in Step 1. Slide the switch into the
bracket. Switch can be inserted into either side of the bracket as needed.
2) Using the 1.3 mm hex wrench (supplied) torque the switch set screw to 10-12 in-oz in Step 2.
3) Place the bracket onto the tie-rod making sure it is fully seated and the nut is under the tie-rod, then slide
the bracket to the desired switch location. Step 3
4) While holding the switch side of the bracket snugly against the cylinder tube, tighten the bracket set screw
to 7-10 in-lbs. Step 4
ต้องการสอบถามราคา รายละเอียดสินค้า กรุณาแจ้งยี่ห้อ รุ่น จำนวน เข้ามาที่